Patterned langmuir-blodgett films of monodisperse nanoparticles of iron oxide using soft lithography

Langmuir-Blodgett (LB) films of monodisperse iron oxide nanoparticles have been successfully deposited onto patterned poly(dimethylsiloxane) surfaces. These patterned LB films of iron oxide nanoparticles were transferred onto solid substrates using micro contact printing.     

Investigation on the Performance of Supported Molybdenum Carbide for the Partial Oxidation of Methane

The performance of uspported and unsupported molybdenum carbide for the partial oxidation of methane (POM) to syngas was investgated.An evaluation of the catalysts indicates that bulk molybdenum carbied has a higher methane conversion during the initial stage but a lower selectivity to CO and H2/CO ratio in the products.The rapid deactivation of the catalyst is also a significant problem.However,the supported molybdenum carbide catalyst shows a much higher methane conversion,increased selectivity and significantly improved catalytic stability.The characterization by XRD and BET specific area measurements depict an improved dispersion of molybdenum carbide when using alumina as a carrier.The bulk or the supported molybdenum carbide exists in the β-Mo2C phase,while it is transformed into molybdenum dioxide postcatalysis which is an improtant cause of molybdenum carbide deactivation.     

笼形聚氨肟树脂的研究：碱处理对吸附性能的影响

研究碱处理的笼形聚氨肟树脂（ＢＣＡＯ）对二价金属离子的吸附行为。吸附结果若生成２：１配的，得Ｍｇ＾２＋，Ｃａ＾２＋，Ｂａ＾２＋，Ｍｎ＾２＋，Ｃｏ＾２＋，Ｎｉ＾２＋，Ｚｎ＾２＋，Ｃｄ＾２＋，Ｐｂ＾２＋，Ｃｕ＾２＋离子的吸附效率分别是２７．１、２９．２、３０．４、２９．０、２７．１、３０．８、４５．０、３９．８、６０．３、６２．１％，Ｈｇ＾２＋离子的吸附效率高达１０５％，表明在吸附过程中同时生成２：１     

Preparation and properties of polyarylates from 5-t-butylisophthaloyl chloride and various bisphenols

Polyarylates containing a t-butyl pendant group were prepared from 5-t-butylisophthaloyl chloride and various bisphenols through the phase-transfer catalyzed two-phase polycondensation. The polyarylates having inherent viscosities up to 3.1 dL/g were obtained quantitatively. They were readily soluble in various solvents such as chloroform, m-cresol, and pyridine. Coloreless, transparent, and flexible films could be cast from the chloroform solutions of the polymers. The polyarylates had glass transition temperatures between 210 and 320°C, and did not lose weight below 350°C, with 10% weight loss being recorded at 395–450°C in air.     

脊髓小脑变性疾病病人血清铜,锌,铝,铁含量的研究

脊髓小脑变性疾病（ＳＣＤ）的病因可能与遗传、神经生化紊乱、感染、微量元素平衡障碍及自由基损伤等因素有关，其中微量元素平衡障碍的研究具有重要意义。检测了ＳＣＤ中发病率较高的橄榄桥小脑萎缩症（ＯＰＣＡ）及晚发性小脑皮质萎缩症（ＬＣＣＡ）病人１５例血清中铜、锌、铝、铁等微量元素含量。发现病人比对照组铜明显降低，Ｐ〈０．０１；锌明显降低，Ｐ〈０．０１；铝明显升高，Ｐ〈０．０１；铁无明显差别。     

过敏性哮喘患者血清中10种必需微量元素水平的研究

３４例过敏性哮喘患者血清中铁，锌、铜，锰硒铬，钴镍，钡，钼的含量水平与对照组比较，揭示：（１）铁，铜，铬的含量升高；（２）硒，镍，钴、钒的钼的含量降低；（３）锌和锰的含量差异无显著性，Ｐ〉０．０５。     

X射线荧光光谱法在稀土元素分析中的应用

本文研究了Ｘ射线荧光光谱在混合稀土氧化物和高纯稀土氧化物分析中的应用，并探讨了在常量分析中影响分析准确度和精密度的主要因素；样品及标样制备，基体效应校正方法在痕量分析中降低检测限的方法，选择最佳测量条件，降低背景，与分离富集手段相结合，取得满意的结果。     

Microcalorimetric investigation of the growth of the <Emphasis Type="Italic">Escherichia coli</Emphasis> DH5α in different antibiotics

The effects of Amoxicillin Sodium and Cefuroxime Sodium on the growth of E. coli DH5α were investigated by microcalorimetry. The metabolic power-time curves of E. coli DH5α growth were determined by using a TAM air isothermal microcalorimeter at 37°C. By evaluation of the obtained parameters, such as growth rate constants (k), inhibitory ratio (I), the maximum heat power (P _m) and the time of the maximum heat power (t _m), one found that the inhibitory activity of Amoxicillin Sodium vs. E. coli DH5α is enhanced with the increasing of the Amoxicillin Sodium concentration, and the Cefuroxime Sodium has a stimulatory effect on the E. coli DH5α growth when the concentration is about 1 μg mL⁻¹. The IC₅₀ for the Amoxicillin Sodium and the Cefuroxime Sodium are 1.6 and 2.0 μg mL⁻¹, respectively, it implicates that the E. coli DH5α is more sensitive to Amoxicillin Sodium than Cefuroxime Sodium.     

超疏水涂膜的研究进展

超疏水涂膜以其独特的性能，在国防、工农业生产和日常生活中有着广泛的应用前景。但目前的制备技术制约了其在建筑外墙涂料等大型设施方面的应用。探索如何采用简单有效的方法构造和调控涂膜的双微观结构，从而获得性能持久优异的超疏水性涂膜，并有效应用于生产和生活的各个方面是这一领域研究的最终目标。本文就超疏水材料表面理论的发展和近几年来超疏水膜制备技术取得的新成果进行了概括，并指出制备超疏水涂膜存在的问题和发展方向。利用表面能极低的含氟材料，将溶胶－凝胶、相分离技术和自组装梯度功能等技术有机结合，获得适宜的表面粗糙度和微观构造，是实现超疏水涂膜工业化生产的可行途径。     

Highly photoluminescent multilayer QD-glass films prepared by LbL self-assembly

A novel and facile preparation method for layer-by-layer (LbL) self-assembled films incorporating quantum dots (QDs) and having intense photoluminescence (PL) from blue to red is presented. Functional sol-gel-derived glass layers prepared by the hydrolysis of 3-aminopropyltrimethoxysilane (APS) or 3-mercaptopropyltrimethoxysilane (MPS) have been used as a linkage between QD layers. Absorption, PL spectroscopy, transmission electron microscopy, and atomic force microscopy were employed for characterization, which revealed that the QDs in the prepared films had a nearly close-packed coverage and were not aggregated. The PL efficiencies of the QDs (CdTe or ZnSe, both are thioglycolic acid-stabilized) dispersed in the films were roughly half that of the initial colloidal solutions but reached 24% before a refractive index correction. The thickness of the red-emitting film with 10 CdTe QD layers was approximately 50 nm. The concentration of QDs in the film derived from the first absorption peak was approximately 0.01 M. Because the PL starts to show a red shift, the obtained concentration is practically the ultimate one in the glass matrix. The mercapto, amino, and carboxyl groups play important roles in LbL self-assembling processes.